Fuel Tech PRO500 V8 Complete Harness 2002004769
We Cannot Ship Any Performance Item that Effects the Vehicles Emisions to CA or Carb States that isn’t Carb Approved
Warning: This Product can expose you to chemicals including lead, chromium (hexavalent compounds) and benzene which are known to the State of California to cause cancer and birth defects, or other reproductive harm ( For More information go to www.p65warnings.ca.gov )
New PRO500 V8 Complete Harness
The new PRO500 Harness is an universal V8 harness to use with FT500LITE or FT500 module which replaces the FT500 V8 PRO Harness, 8 injector.
The harness is setup for 2 O2 sensors using 2 Wideband Nanos, it allows sequential fuel injection with 8 high or low impedance injectors, EV1 style connector (requires drivers in this case), reads 3 pressure sensors (PS style), water and air temperature sensor (GM style).
It also has a 8-way connector with outputs to run ignition system, can be COP coils sequential or wasted spark setting, PRO-Nitrous, boost controller or any other feature available in the FT500 line.
Another 10-way connector is ready to receive analog sensors, ready to provide 5V for sensors and run up to 4 outputs from the unit using the yellow wires. It has crank and cam connectors to read hall effect or VR sensors.
The harness is also designed to use FuelTech CAN communication with the Wideband Nanos and it is able to receive other FuelTech modules that operate with CAN bus system.
To make it easier to remove the engine from the car, the new PRO500 Harness has a CPC firewall connector that separates inner and engine side of the harness.